Maya and the Unicorns

IMG_0007

This is my second go at the Maya bra, and I’ve been saving this fun unicorn fabric from LillyandMimistore on Etsy (and apparently comes in 3 colours). The Maya bra pattern is kindly available from here for free. Here was my first attempt.

IMG_0010

My previous Maya bra wasn’t a bad fit, but needed a pinch taken out of the upper cup. Here is how I went about changing the pattern.

I’ve taken the foam pattern piece, it has no seam allowance top and bottom, and made 3 cuts top to bottom leaving a tiny piece of paper as a hinge.

Then I’ve overlapped the two pieces at each cut and stuck them back down.

This has reduced the volume but left me with slightly funny shaped pieces that need adjusting. On the top edges I’ve reconnected the corners with straight lines.

On the bottom edge I was worried about changing the original shape so I traced the original shape edge back on.

And added some seam allowance to give the final piece below.

Not the most beautiful photos, apologies.

After that I constructed the bra as before, this time I tried using ribbon to cover the seams of the cut and sew foam rather than lining it. I think I preferred lining, but I like to try different techniques to see what I like best.

IMG_0012

I had a couple of issue, once again applying the elastic it stretched under the arm as my machine struggled to cope with the layers. This means I have a slightly gappy underarm section. I’ve decided to take a small pinch out of the wing next time so that if it stretches a little it won’t be a problem. I might lower the height of the under-arm too.

IMG_0014

The second issue is that I still need to take a little more from the upper cup. I erred on the side of caution, it’s a much better fit than before but a little more would be good. The bridge fits flat against my chest and the wires are in the correct place, less than a cm reduction should do it.

This little bow I made from two pieces of ribbon.

IMG_0011

Generally it just fills me with lots of happiness. It’s so beautiful and colourful. My entire reason for starting making bras was because I was fed up with the lack of fun bras bigger than a DD cup.

This week I’m going to purchase the scrundies pattern and make some matching knickers.